Shaft Alignment Part 1



This video is intended to guide a user through the shaft alignment process for a typical mid engine, direct drive tournament Ski Boat. Vee-Drive ski boats require additional steps and instruction. All Boat and Engine manufacturers recommend checking coupling alignment annually, and adjusted as needed.

NOTE: This video assumes that your boats strut is in good condition, a twisted, bent, improper factory strut installation will cause pre-mature bearing wear, and make alignment very difficult. If your shaft does not want to position itself in the center of the shaft log while holding the “heavy-end” up to compensate for the weight of the un-supported coupling end, you will need to address a strut problem. Feel free to call with these issues for assistance. (985) 542-4336 RonT

For all your ski boat part needs check out our webpage below

Like us on Facebook

source

About the author